2021 XL Specialized XL Low-Profile HDG: 18" Deck Height XL 110 HDG

Information

2021 XL Specialized XL Low-Profile HDG: 18" Deck Height XL 110 HDG

With 18-inch loaded deck height and drop bolsters in the rear at 37-inches tall, this lowboy is ready to haul your equipment under low bridges. The seven position manual ride height adjustment in the rear and five position variable ride height in the gooseneck enable even more deck adjustment based on the load. Haul with confidence thanks to a capacity rating of 110,000 pounds in 12 feet and i-beam cross members on 12-inch centers, and a five year structural warranty.

Features may include:
  • Loads and hauls tall equipment with an 18” deck height
  • Deep well for long booms, no need to detach lower boom section
  • A low rear transition angle lowered bolsters allows for easy loading of equipment over rear deck.
  • Heavy duty outriggers allow loading of heavy wide track units
  • Plenty of tie downs for hard to secure loads
  • D.O.T. approved 12V sealed Grote harness with 7 year warranty
  • Always striving to surpass market standards, all new XL products feature a 5 year structural warranty
  • 26’ of well for transporting large equipment
  • XL’s one piece construction results in stronger products. Trailer I-beams are made from one piece web and flange and then welded on all sides
  • 1-3/8" raised Apitong decking (center open) is more durable than Oak and stands up to years of wear
  • 5 position variable ride height
  • Bucket well provides needed room in the rear bridge
  • Frame reinforcement for a single axle Booster

Photos

Highlights

  • Richland, Mississippi
  • 2021
  • XL Specialized
  • XL Low-Profile HDG: 18" Deck Height XL 110 HDG
  • 8" & 4" Stubbed Jr. I-Beam Cross Members On 12" Alt. Ctrs. | (4) 12" Fully Cambered I-Beams
  • Available
  • 5th Wheel: 51" | Loaded Main Deck: 18" | Loaded Rear Bridge Deck: 41"

Specifications

  • 2021
  • XL Specialized
  • XL Low-Profile HDG: 18" Deck Height
  • XL 110 HDG
  • Flatbed
  • 13' Low-Profile Neck With Relief Cut-Out | Swing Clearance: 110" & 84" | Front Flip Ramps: 31" | Axle Spacing: 54 1/2"
  • Main Deck: 26' | Rear Bridge: 14'
  • 5th Wheel: 51" | Loaded Main Deck: 18" | Loaded Rear Bridge Deck: 41"
  • 53'
  • 102"
  • 16" & 42"
  • 6"
  • 110,000 Lb In 12'
  • 25,000 lb Nominal
  • 8" & 4" Stubbed Jr. I-Beam Cross Members On 12" Alt. Ctrs. | (4) 12" Fully Cambered I-Beams
  • 3
  • 7 Pole Electrical Socket
  • D.O.T. Approved 12v Sealed
  • Rubber mounted Led lights | (1) Mid-Turn Signal Per side | (2) Clearance Lights Per Side | 2 Tail Light Package With Aluminum Cover
  • 8.25 X 22.5 Steel Rims
  • 255/ 70R/ 22.5 H Rated Tires
  • 25,000 lb Air Ride | Raise And Lower Valve | Manual Ride Height Control
  • 16 1/2" X 7" | Spring Brakes On 1 Axle
  • Black | IH Red | Cat Yellow
  • 5 Position Variable Ride Height | Hydraulics Run Off Of Wet Kit | Air Operated Lock W/ Manual Safety Latch | Brackets For Power Unit | Work Light | T-I Flange, 80k Web | (7) Bent D-Rings Per Side | Toolbox In Front | 4) Flat-D-Rings In Toolbox | (13) Chain Drops Per Side | Swing Out Outriggers On 24" Centers | Heavy Duty Flatback Outriggers At Front | Bucket Well At Rear, Plate On Bottom | (4) Flat D-Rings In Bucket Well | (2) Flag Holders | Front Ramp Upper Flange Reinforcement | Rear Transition With 32° Slope | Open Wheels With Bolsters Dropped 4" | Open Boom trough | (2) Flat D-Rings On Main Beams At Rear | (2) Chain Drops On Each Bolster | (2) Stake Pockets In Tail Channel For Wide Load Sign | Frame Reinforcement For Booster | Angled Control Panel | (2) Flag Holders | Air Lift On 3Rd Axle | Hub Pilot, Outboard Drums | Limit Chains On All Axles | Auto Slack Adjusters | Air & Electric Done After Paint
  • 1 3/8" Raised Apitong Decking - Center Open
  • Paint: 1 Year